Accesories

Seal for higher protection category. Cannot be used together with detector plates. Data sheet A6V10202198, A6V10277374 Color transparent ...

Pre-assembled resistors with fork lugs that can be easily installed in the DB110 and DB110 signaling bases Have DB721D installed to set the OOH74...

For mounting the air sample smoke detector set on round and insulated ventilation ducts. Data sheet A6V10405166

The top-hat mounting rail allows various devices to be mounted. Dimensions (W x H) 35 x 122 mm Package contents: 10 pieces.

The top-hat mounting rail allows various devices to be mounted. Dimensions (W x H) 35 x 288 mm

To identify the location address. The number corresponds to the installation drawing. The font size can be up to 10 mm in an area of ​​60 x 20 mm....

The replacement key fits all housings for manual call points DMA1192-xx, FDMH293-x, FDMH273-x, FDMH297-x. Data sheet A6V10236643 Packaging uni...

To protect the detector against damage. Can only be used wet together with the base accessory. Dimensions (Ø x H) 160 x 126 mm

With the additional frame, the alarm indicator can be used in surface-mounted pipe or duct entries, to enlarge the loop space or as an adapter for...

Flat rear wall if a particularly flat type of installation is required and the cables are flush-mounted become. Instead of the back wall that is ...

Can be used as a spare part for the telescopic rods FDUM291 and FDUM292.

Can be used as a spare part for the FDUL221 line test device.

For operating the fire detectors in critical environmental conditions, when there is icing or there is a risk of condensation, e.g. B. for cold st...

To ensure that several branch lines do not fail in the event of a short circuit, line separators can be connected between them. The line separator ...

To identify the location address for detector bases. Data sheet 007775 Color transparent Dimensions (W x H) 62 x 35 mm Packaging content: ...